Measurement unit
Measurements
Feet, Metres, Inches, Centimetres, Millimetres
Skirting Calculator
Measure room perimeters, deduct doors and count skirting pieces.
Open this toolSkirting follows the room perimeter, with doorway gaps deducted from the length that actually receives pieces.
Measure each room, list doors and choose the purchased piece length. Add a cutting allowance before checking the rounded purchase count.
Inputs and controls
Total door widths to deduct
Measurements
Allowed range: 0 to 100000000
Piece length
Skirting order · ft
Allowed range: 0.01 to 1000
Ordering allowance
Skirting order · %
Allowed range: 0 to 100
Added once to the measured requirement.
Price per piece
Skirting order · PKR / piece
Allowed range: 0 to 1000000000
Optional. Enter your own supplier quote.
Room
Room schedule
Length
Room schedule
Allowed range: 0.001 to 100000
Width
Room schedule
Allowed range: 0.001 to 100000
Quantity
Room schedule
Allowed range: 1 to 1000
How to use
- Choose measurement unit. Enter total door widths to deduct.
- Enter piece length, ordering allowance and price per piece.
- Add the entries in room schedule as separate rows. Include room, length, width and quantity for each row.
- Select Calculate estimate. Read the returned values alongside the assumptions below before copying, exporting or acting on the result.
Why use this tool
A perimeter schedule makes it easier to spot repeated door deductions and compare standard piece lengths at the supplier.
Before relying on the result
Door widths are deducted once from the total room perimeter. Corner cuts are covered by your allowance.
Tool limitations
Door widths are deducted once from the total room perimeter. Corner cuts are covered by your allowance.
Questions
Are door widths deducted more than once?
No. Each listed door width is deducted once from the total room perimeter. Check the room list for repeated entries.
What should I check before using Skirting Calculator?
Check Measurement unit, Total door widths to deduct, Piece length and Ordering allowance. Use the exact units shown beside the controls and replace any example values with your own inputs.
Source page last modified: 2026-10-01T14:08:57+00:00. This profile describes the tool; use its page to run it.
Markdown profile