Measurement unit
Schedule units
Feet, Metres, Inches, Centimetres, Millimetres
Steel Bar Weight Calculator
Build a bar schedule with lengths, quantities and weights.
Open this toolA steel order is easier to check when bar lengths and quantities are written down before the total weight is calculated.
Build the schedule from the specified diameters and cut lengths. Keep bends, supplier tolerances and delivery weights in mind when comparing the theoretical total with a quote.
Inputs and controls
Steel density
Schedule units · kg/m³
Allowed range: 1000 to 20000
Ordering allowance
Schedule units · %
Allowed range: 0 to 100
Added once to the measured requirement.
Steel quote
Steel quote · PKR / kg
Allowed range: 0 to 1000000000
Optional. Enter your own supplier quote.
Reference
Bar schedule
Diameter
Bar schedule · mm
Allowed range: 1 to 100
Cut length
Bar schedule
Allowed range: 0.001 to 100000
Number of bars
Bar schedule
Allowed range: 1 to 100000
How to use
- Choose measurement unit. Enter steel density and ordering allowance.
- Enter steel quote.
- Add the entries in bar schedule as separate rows. Include reference, diameter, cut length and number of bars for each row.
- Select Calculate estimate. Read the returned values alongside the assumptions below before copying, exporting or acting on the result.
Why use this tool
Individual bar rows give you a traceable weight calculation rather than one unexplained steel allowance for the entire building.
Before relying on the result
Nominal cylindrical steel weight. Diameter tolerances, bends and supplier weights can differ.
Tool limitations
Nominal cylindrical steel weight. Diameter tolerances, bends and supplier weights can differ.
Questions
Is the calculated weight a delivery guarantee?
No. It uses nominal cylindrical dimensions. Actual diameter tolerances, bends and supplier measurement methods can produce a different delivered weight.
What should I check before using Steel Bar Weight Calculator?
Check Measurement unit, Steel density, Ordering allowance and Steel quote. Use the exact units shown beside the controls and replace any example values with your own inputs.
Source page last modified: 2026-10-01T14:08:57+00:00. This profile describes the tool; use its page to run it.
Markdown profile