WhatsOnTool directory

Rebar Mesh Quantity Calculator

Count specified mesh bars and estimate steel weight.

Open this tool

Mesh quantities depend on the specified bar spacing, cover and lap details. Those choices must come from the project drawings.

Enter the layout you have been given and review counts in both directions. Use the result to check quantities, with reinforcement design handled by the responsible engineer.

Inputs and controls

Measurement unit

Specified mesh

Feet, Metres, Inches, Centimetres, Millimetres

Slab length

Specified mesh

Allowed range: 0.001 to 100000

Slab width

Specified mesh

Allowed range: 0.001 to 100000

Specified edge cover

Specified mesh · mm

Allowed range: 0 to 1000

Spacing across width

Specified mesh · mm

Allowed range: 1 to 3000

Spacing across length

Specified mesh · mm

Allowed range: 1 to 3000

Specified bar diameter

Steel requirements · mm

Allowed range: 1 to 100

Layers

Steel requirements

Allowed range: 1 to 10

Extra lap length per bar

Steel requirements · mm

Allowed range: 0 to 10000

Steel density

Steel requirements · kg/m³

Allowed range: 1000 to 20000

Ordering allowance

Steel requirements · %

Allowed range: 0 to 100

Added once to the measured requirement.

Steel quote

Steel requirements · PKR / kg

Allowed range: 0 to 1000000000

Optional. Enter your own supplier quote.

How to use

Why use this tool

A layout based count helps explain where the steel total comes from when checking a slab material schedule.

Before relying on the result

Counts a specified layout. Bar size, cover, spacing and laps must come from your project drawings; this tool does not design reinforcement.

Tool limitations

Counts a specified layout. Bar size, cover, spacing and laps must come from your project drawings; this tool does not design reinforcement.

Questions

Does the tool select safe bar spacing?

No. It counts an entered arrangement. It cannot establish the required bar diameter, spacing, cover or structural adequacy.

What should I check before using Rebar Mesh Quantity Calculator?

Check Measurement unit, Slab length, Slab width and Specified edge cover. Use the exact units shown beside the controls and replace any example values with your own inputs.

Source page last modified: 2026-10-01T14:08:57+00:00. This profile describes the tool; use its page to run it.

Markdown profile