Shape
Pour shape
Rectangular slab, Circular column / pad, Strip footing
Concrete Volume Calculator
Measure slab, cylinder and strip pours before ordering concrete.
Open this toolA slab, round column and foundation strip need different measurements. Putting every pour into a single rough volume can hide expensive omissions.
Choose the matching shape and enter measured dimensions before adding an order allowance. Keep the measured volume separate from the quantity you ask the supplier to deliver.
Inputs and controls
Measurement unit
Pour shape
Feet, Metres, Inches, Centimetres, Millimetres
Length
Pour shape
Allowed range: 0.001 to 100000
Width
Pour shape
Allowed range: 0.001 to 100000
Diameter
Pour shape
Allowed range: 0.001 to 100000
Thickness or height
Pour shape
Allowed range: 0.001 to 100000
Identical pours
Pour shape
Allowed range: 1 to 10000
Ordering allowance
Concrete order · %
Allowed range: 0 to 100
Added once to the measured requirement.
Ready mix quote
Concrete order · PKR / m³
Allowed range: 0 to 1000000000
Optional. Enter your own supplier quote.
How to use
- Choose shape and measurement unit. Enter length, width, diameter, thickness or height and identical pours.
- Enter ordering allowance and ready mix quote.
- Select Calculate estimate. Read the returned values alongside the assumptions below before copying, exporting or acting on the result.
Why use this tool
Shape based measurements make small pours easier to check, especially when a project combines rectangular sections with cylindrical elements.
Before relying on the result
Volume and order quantities only. It does not select concrete strength or reinforcement.
Tool limitations
Volume and order quantities only. It does not select concrete strength or reinforcement.
Questions
Does it choose the concrete strength?
No. Strength, reinforcement and placement requirements belong in the project specification. This calculator estimates volume and ordering quantities only.
What should I check before using Concrete Volume Calculator?
Check Shape, Measurement unit, Length and Width. Use the exact units shown beside the controls and replace any example values with your own inputs.
Source page last modified: 2026-10-01T14:08:57+00:00. This profile describes the tool; use its page to run it.
Markdown profile